User manual

17
1. Overview 2. Setup & Use
3. Optional
Accessories
4. Troublshooting
5. Warranty, Safety
& Specifications
4. CHARGING THE REDMIKE
Before use, the REDMIKE should be charged. It will take 8-9 hours for the
REDMIKE to obtain a full charge. A fully charged REDMIKE will last for over 7
hours of use. If microphones are used daily, they should be kept in the cradle –
microphones can be left in a charging cradle constantly for up to 2 weeks without
causing degradation to battery life.
A red light on the charging cradle indicates the REDMIKE is charging. A green
light indicates that charging is complete and a full charge has been reached. A
blinking light indicates a charging or sensing error. See Troublshooting section
for more information.
REDMIKE incorporates alkaline protection into the microphone design. Always
use a Lightspeed rechargeable sensing battery. Replacement AA NiMH batteries
may only be purchased through Lightspeed Technologies (part # BA-NH2A27).
Do not attempt to charge alkaline batteries. They can overheat and expand
creating a significant hazard and damaging the microphone (this is not covered
by warranty).
1. Plug power cord into the cradle
charger and then plug the AC end
into an electrical outlet.
2. Ensure that the REDMIKE is turned
OFF.
3. Place the REDMIKE into the
cradle. The LED on the cradle
will glow RED indicating charging
has started. When the REDMIKE
is fully charged the LED on the
cradle charger will change to
GREEN.