Installation Guide

www.sureheat.com
200311-01C10
Figure 5 - Removing Front Panel
INSTALLATION
FASTENING HEATER TO WALL
REMOVING FRONT PANEL
Screw
Front
Panel
1. Remove 4 screws securing front panel.
2. Carefully slide front panel forward.
Mounting Bracket
The mounting bracket is located on back panel
of heater. It has been taped there for shipping.
Remove mounting bracket from back panel.
Methods For Attaching Mounting
Bracket To Wall
Use only the last hole on each end of mount-
ing bracket to attach bracket to wall. Attach
mounting bracket to a wall only in one of two
ways:
1. Attaching to wall stud: This method pro-
vides the strongest hold. Insert mounting
screws through mounting bracket and into
wall studs.
2. Attaching to wall anchor: This method
allows you to attach mounting bracket to
hollow walls (wall areas between studs)
or to solid walls (concrete or masonry).
Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.
LOCATING HEATER
This heater is designed to be mounted on a wall. For convenience and efciency, install heater:
1. Where there is easy access for operation, inspection, and service.
2. In the coldest part of room.
When installing the appliance directly on carpeting, tile or other combustible material other
than wood ooring, the appliance shall be installed on a metal or wood panel extended the
full width and depth of the appliance.