Installation Guide
RDQCI5283 Rev. 0 Page 8 Cered 06/01/2016
On the interior face of the glass, place a strip of
low tack tape on the glass about 1/8” to 3/16”
away from edge of the u-channel both vertically
and horizontally. Run a small bead of silicone
along this edge. Next, on the interior, run a
bead of silicone between the u-channel and the
threshold and also between the u-channel and
the wall. After completing, remove the tape be-
fore silicone sets.
NOTE: DO NOT USE the shower until the silicone is completely cured. Check the tube
of silicone for the manufacturer recommended cure time (typically 24 - 48 hours).
Using suction cups, set the Fixed Panel Glass back
into position. Double check exposed edges of the
glass are level and plumb.
Exposed edges MUST be level and plumb before
moving to next step.
Place the clamp cover plate on the outside of the glass
and secure from the inside w/ the screw provided.
COVER PLATE
INSIDE
SCREW
INSIDE
GASKET—BOTH SIDES OF
RDQCI5283 Page 8 of 13
Date Certified: 06/16/2016