Installation Guide
RDQCI5285 Rev. 0 Page 12 Cered 06/01/2016
RDQCI5285 Rev 0 Page 12 Cered 06/17/2016
Place the Drip Vinyl onto the bottom of the door panel.
Line it up on the hinge side of the door and cut it off
flush with the strike edge of the door.
NOTE: The sweep may be pulled up or
down on the glass to adjust how much of
the sweep contacts the threshold
On the interior face of the glass, place a strip of
low tack tape on the glass about 1/8” to 3/16”
away from edge of the u-channel both vertically
and horizontally. Run a small bead of silicone
along this edge. Next, on the interior, run a
bead of silicone between the u-channel and the
threshold and also between the u-channel and
the wall. After completing, remove the tape be-
fore silicone sets.
NOTE: DO NOT USE the shower until the silicone is completely cured. Check the tube
of silicone for the manufacturer recommended cure time (typically 24 - 48 hours).
TIP: Run a small bead of silicone on the in-
side edge of the drip vinyl and the glass to se-
cure the vinyl sweep and prevent water from
collecting inside the sweep if adjusted.