SERIES: 2000 CONFIGURATION: Door-Door MOUNTING PACKAGE: Frameless Sliding Door RDQCI5017 Rev.
Tools: To install your New Shower Enclosure, you may need the following: Drill Pencil Hack Saw 1/8” & 3/16” Drill Bit Low Tack Tape Caulk Gun Center Punch Tape Measure Clear Silicone Caulk Files 4’ & 6’ Levels Suction Cups #2 Phillips Screwdriver Safety Notes: This unit is best installed by two people. Handle the glass panels carefully and protect the edges.
PARTS LIST ITEM DESCRIPTION QTY.
EXPLODED VIEW RDQCI5017 Rev.
SHOWER HEAD LEFT 1 SHOWER HEAD RIGHT This framess bypass sliding enclosure is supplied with pocketed wall jambs [A]. The jambs are notched on both ends to fit over the bottom track. It is important to determine the proper orientation of the unit before marking and drilling the walls. For maximum waterproofing, position the “open” pocket of the wall jamb to the interior for the shower head wall. This will force the interior panel to be on the shower head side.
4 Before replacing the track, force a slight downward bow into it. This will ensure that the track fits tight to the threshold in the middle. SIL ICO NE Run a bead of silicone on both flat surfaces on the bottom of the track. Then replace the track onto the threshold using the pencil marks from step #3 as a guide. Be sure the raised side is on the exterior. 5 Replace one wall jamb and attach it to the wall with the #8 x 1 1/2” truss head screws [D].
Attach the four black heavy-duty roller bearings [M] to the door hanger brackets [H] as shown using the #8-32 x 3/8” hex head screws [N]. The rollers should be approximately in the center of the slots of the bracket fins. 8 Place one panel [J] on the inside of the shower/tub with the rollers facing the back wall and the textured side of the panel facing the outside (if applicable). Set it on a drop cloth or piece of cardboard to protect the glass and the shower/tub surface.
10 Place one of the clear bottom guides [V] in the middle of the tub track as shown. Using the hole in the back of the bottom guide, drill a 1/8” hole into the inside of the tub track. Attach the bottom guide with a #6 x 3/8” pan head screw [W]. Exterior 11 Remove the protective backing from the two squares of tape on the back side of the nylon jamb covers [X]. Place the jamb covers against the wall jambs over the notches of the wall jambs at the top, inside of the header. Press in place.
Neatly silicone each end of the tub track where it fits into the wall jambs as well as the seam between the wall and the wall jamb and the curb and threshold on the inside of the shower. SIL IC ON E SIL IC ON E 13 NOTE: Silicone on the exterior seam is optional. NOTE: DO NOT USE the shower until the silicone is completely cured. Check the tube of silicone for the manufacturer recommended cure time. (typically 24 - 48 hours) RDQCI5017 Rev. 0 RDQCI5017 Rev.
Tile Ready® Brand Shower Pan Installation Addendum SPECIAL INSTRUCTIONS FOR REDI DOOR® ENCLOSURE INSTALLATIONS WITH TILE READY® BRAND SHOWER PANS Designated screw pack for Tile Ready® Brand Shower Pans: For Redi Door® enclosure installations with a Tile Ready® brand shower pan, a special screw pack containing eight (8) #8x¾” pan-head screws is included with your door. These #8x¾”screws replace curb screws included in the main hardware package, and their use is mandatory.