Installation Guide

&6HWWKHÀUVWEORFNDQGODVWEORFNRIWKHQH[WURZ

into the side channels on top of the

“FLAT” spacers.

D. Install the remaining blocks in the row in the same

PDQQHUDVWKHÀUVWURZ

• Apply 3/8" to 1/2" of mortar to the edge of each

block that meets a previous block. Apply mortar

to both edges of the last block installed in the row.

•Be sure to insert “REGULAR” spacers with the cross

arm down, where two blocks meet.

3XVKWKHEORFNVÀUPO\LQSODFHIRUPLQJ

mortar joints. Make sure the joints are completely

ÀOOHGZLWKPRUWDU

•Remove excess mortar with a polyfoam brush,

 DQGÀOODQ\YRLGVRQERWKVLGHVRIWKHSDQHO

•Check periodically to ensure that the blocks are

straight, level and plumb. Adjust as needed.

E. Repeat Steps 6A - 6D to install each row of block,

except for the next to last row.