Installation Guide

G. Place the second block using a “T” spacer on the

bottom and “REGULAR” spacer at the top with the

spacer cross arm between the two blocks. Push the

two blocks together.

H. Follow this procedure for all remaining block in the

ÀUVWURZH[FHSWIRUWKHODVWEORFN

J. Check periodically to ensure that the glass blocks

are straight, level and plumb.

Note: ,I\RXÀQGDSUREOHPDGMXVWWKHEORFNLQWRSODFH

with a rubber mallet before proceeding.

F. Apply 3/8" to 1/2" of mortar to the vertical

edge of the second

block that will

contact the

preceding

block.

K. Using a polyfoam brush, remove excess mortar

 DQGÀOODQ\YRLGVRQERWKVLGHVRI\RXUSDQHO

, ,QVWDOOWKHODVWEORFNVLPLODUWRWKHÀUVWEORFN

inserting an “L” spacer

at the lower

outside corner

so that the

cross arm

is at the

bottom,

between

the block

and the

curb.