How to Guide

14
B. For walls with curves and/or angles it is recommended that you
layout the first coarse of block for your wall before constructing
a curb.
C. Make sure the curved and/or angled sections of your opening or
curb are configured correctly.
D. The curb must be as wide as, or wider
than, the glass block thickness.
E. Apply finish material to the curb. If in-
stalling the glass blocks in a wet envi-
ronment, take steps to ensure that the
curb is waterproofed.
F. Use a level to make sure the opening is
level and plumb.
G. Verify all measurements. Remember, for rough opening’s total
height, add 1/4” to width measurement
H. If there are any problems with the opening or curb, adjust it before
proceeding.
I. Available shapes and finishing pieces,
with corresponding Series/Collections:
Block Shapes Series/Collection
ALLBEND
™
22.5
o
4” and 80mm
90
0
Radius Corner 4” and 80mm
90
0
Sharp Corner 4” and 80mm and MYMINIGLASS™
Endblock
™
4” and 80mm and MYMINIGLASS™
Double End 4” and 80mm and MYMINIGLASS™
TRIDRON
®
45
o
4” only
1C
TRIDRON
®
45°
Curb Layout
Allbend
™
22.5°
Curb Layout
1F
Support
Wall
Support
Wall