How to Guide

2A
5
5. Insert wall anchors into the ends of the horizontal spacer where
it meets a jamb. Make sure center finger of wall anchors fit into
the top of the center groove of the spacer.
6. Place the spacer in the bottom of the opening, centered in the
section. DO NOT install with screws.
B. AllBend
™
Curved Wall Sections
16
4. For EndBlock
™
, trim the end of the horizontal spacer to fit the
shape by cutting the two corners at a 45
°
angle 3/4” from each
corner.
2A
6
(test Fit the First rOw COntinued)
2A
4
3/4
Inch
3/4
Inch
45
°
Angle
1. Find the seam at the edge of an AllBend
™
(22.5°) horizon-
tal spacer. Pry the spacer apart into two pieces. Remove the
barbed tabs from one half. (4” and 80mm only)