User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 48 of 152 March 2, 2011
4.7 PMP System Configuration Screen
Click Configure System in the main menu to view and adjust configuration settings for
general system identification, Ethernet, and the wireless interface. The fields specific to
PMP are highlighted.
4.7.1 Ethernet Interface
Use settings in the Ethernet section of the screen to configure the AN-80i Ethernet
interface. These fields are common for PTP and PMP modes of operation with the
following exceptions:
Flow Control: PTP only.
Prioritized Low Latency Mode: PTP Only
SNMP Enable: SNMP v2 only in PMP mode.
See 3.4.1: Ethernet on page 31 for information on all Ethernet fields.
4.7.2 Wireless Interface
Use settings on this section of the screen to configure the AN-80i wireless interface. This
section describes fields specific to PMP mode. See the PTP section Wireless on page
27 for details about all other fields.
Fig. 22: Web - PMP - Wireless Configuration Screen
Auto scan: (PMP SS only) Check this box
to enable the subscriber to automatically
scan available channels to locate and register with a sector controller.
Click the blue text [Frequency Ranges] adjacent to the check box to display the
Frequency Management screen (see Frequency Range on page 75). The sector
controller can be programmed with a master list of frequency ranges. When a subscriber
registers with the sector controller, the programmed frequency ranges are downloaded
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]