User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 89 of 152 March 2, 2011
Table 21: CLI - load
For example: dsa_key_00-09-02-00-01-02.pem
* RSA is not used for SSH Connections in v4.00 and higher.
** Not used in v3.00 software release.
Specify where to store the security information.
usr User entered files (default if type is not specified).
factory Default files.
fips FIPS mode files.
For example:
load file 192.168.25.10 ssl_key_00-09-02-00-b2-73.pem usr tftp
idtable (no parameters)
Load all IDs from flash memory (PMP only). This can be used to restore all IDs from the
last saved configuration.
script <server IP> <filename>
Use this command to load the AN-80i configuration information from a file (created using
script command) located on a remote TFTP server. The file must be located in the TFTP
default directory. The 'save config' command must be used to save the loaded
configuration in non volatile memory. A reboot may be required to activate the loaded
configuration settings.
For example:
load script 192.168.25.10 AN80i-Unit035-091121.cfg
Note: Beginning with v13.00:
i) All Links, Groups, and Connections must
be within the prescribed ranges. Refer to Table
78: Spec. - Provisioning Table ID Ranges on page 149.
ii) The 'load script ...' command rejects all ID references greater than 511.
6.1.10 Logout
Use the logout command to terminate the current Telnet session.
Table 22: CLI - logout
End the current Telnet session.
logout
Terminate the current Telnet session (no parameters).
6.1.11 New
Use the new command (PMP only) to create a new Link, Group, or Connection.
Table 23: CLI - new
Create a new link, group, or connector (PMP only).
new <conn> <group> <link>
conn <id>
Create a new connection ID.
id - Specify a unique ID for this connection:
group <id>
Create a new group ID.
id - Specify a unique ID for this group:
link <id>
Create a new link ID.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]