User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 93 of 152 March 2, 2011
Table 29: CLI - set (Common for PTP and PMP)
on - Enable FIPS mode.
gateway <ip>
Enter the IP address of the default gateway on this segment.
gmt <value>
Enter the time offset from GMT (e.g., -5 for EST).
http <off | on>
Enable or disable the HTTP function. When disabled, the Web interface will not be
available.
off - Disable
on - Enable
https <off | on>
Enable or disable the HTTPS function.
off - Disable
on - Enable
ipaddr <ip> <mask>
Enter the IP address and subnet mask of the AN-80i. Confirmation is required.
Example:
set ipaddr ip 192.168.100.10 mask 255.255.255.0
lkname <text>
Enter the name of the remote unit (maximum 15 characters).
maxtxpower <-10 - 25>
Enter the Tx power level (dBm). This setting is for the transceiver output only. The
actual EIRP depends on the gain of the connected antenna. The maximum
value is determined by the options key.
mgmtag <off | on>
Enable or disable the HTTPS function. See also mgmvid.
off - Do not use VLAN to identify management traffic.
on - Enable VLAN tagged management traffic. See mgmvid.
mgmvid <1 - 4095>
Specify Management VLAN ID. See also mgmtag.
vlan_id - Management VLAN ID.
netmask <mask>
AN-80i IP netmask in standard format.
For example: set netmask 255.255.255.0
optionskey <key> <1 | 2>
Enter the options key string followed by the key position (0 or 1). This command works
silently to validate, save, and activate the key. Event messages are logged for each of
these operations. Enter the 'show log' command to view event messages.
peermac <MAC>
MAC address of the communicating AN-80i. Required for wireless encryption. Use
form: aa:bb:cc:dd:ee:ff
radio <off | on>
Enable or disable the radio transmitter.
off - Disable
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]