Manualshelf

User's Manual

ManualsBrandsRedline Communications ManualsElectronicsOFDM broadband wireless transceiver device
41424344454647484950
User
AN-100U/UX Base Station
Manual
70-00058-01-04 Proprietary Redline Communications © 2010 Page 44 of 136 April 19, 2010
4.2.3 SS Info
Click SS Information in the menu (left side of screen) to view system information,
Ethernet address settings, and wireless statistics for active subscribers.
Figure 20: Web: Monitoring - AN-100UX SS Info Screen
SS Information
Name: User-assigned name for subscriber. Click on the subscriber name (blue text) to
view the service flows settings and statistics.
IP: Secondary management channel (SMC) IP address for this subscriber.
Mgm: Indicates if the subscriber can be managed over the wireless interface. Refer to
the subscriber user manual for additional information about enabling remote
management.
yes: The subscriber supports remote management.
no: The subscriber can not be managed remotely.
DL Mod: Current modulation/coding setting for downlink channel. Displayed value is
updated at one-minute intervals.
UL Mod:Current modulation/coding setting for uplink channel.
Curr CINR: The CINR value is continuously updated based on the last eight (8) frames.
Min CINR: Lowest calculated CINR value since last reboot. Displayed value is updated
at one-minute intervals.
Max CINR: Highest calculated CINR value since last reboot. Displayed value is updated
at one-minute intervals.
Subchan: (AN-100UX only) Indicates subscriber uplink mode. In standard mode uplink
transmission (full) each subscriber uses a reserved time slot and transmits data using all
subcarriers. When uplink subchannelization (USC) is indicated, one or more subscribers
may transmit simultaneously, each transmitting on designated groups of subcarriers.
When USC is mandatory [m] for a subscriber, all service flows on that subscriber are
forced to Best Effort, and the modulation is limited to BPSK 1/2 or QPSK 1/2. Refer to
the full description of this feature in section 7.1: Uplink Subchannelization (AN-100UX
only) on page 110.
Important: Subscribers must be at software v2.1 or higher.
full: Standard mode using all subcarriers (USC mode is not available).
1/2: 8 channel USC.
1/4: 4 channels USC.
1/8: 2 channels USC.
1/16: 1 channel USC.