Manualshelf

User's Manual

ManualsBrandsRedline Communications ManualsElectronicsOFDM broadband wireless transceiver device
61626364656667686970
User
AN-100U/UX Base Station
Manual
70-00058-01-04 Proprietary Redline Communications © 2010 Page 69 of 136 April 19, 2010
4.4.3 Management Interface
Click Management Interface in the system menu (left side of screen) to view and edit
the IP address and DHCP settings.
Figure 31: Web: Configuration - Management Interface Screen
IP Parameters
Obtain IP Parameters from DHCP Server: Select this option to have the base station
obtain its IP address from a DHCP server.
Use the following IP Parameters: Manually enter the following IP parameters:
IP Address: Enter the static base station network IP address.
Subnet Mask: Enter the base station subnet address mask.
Default Gateway: Enter the IP address of the default gateway on the local Ethernet
segment.
Time Server (SNTP): Enter the IP address of the SNTP server.
Use the following checklist to ensure correct display options:
1. Time server must be compatible with SNTP (RFC-2030)
2. Ensure the time zone is correct for your area.
3. If you are in an area that observes daylight savings time, check the box.
Time Zone: Enter the time offset from GMT (hours:minutes).
Daylight Savings: Check to enable automatic time change for daylight savings.
Syslog Server: Enter the IP address of the Syslog server to enable this feature.
Refresh: Click Refresh Time to poll the time server for the current time.