User's Manual

ManualsBrandsRedline Communications ManualsElectronicsOFDM broadband wireless transceiver device

User

AN-100U/UX Base Station

Manual

Table 33: CLI - Interface Command

Command

Parameter/Description

UlMpdus - Resetable -- MAC statistics;

DlSecMgm - Resetable -- MAC statistics;

UlSecMgm - Resetable -- MAC statistics;

DlDefaultSdus - Resetable -- MAC statistics;

UlDefaultSdus - Resetable -- MAC statistics;

Fpc - Resetable -- MAC statistics;

Bwr - Resetable -- MAC statistics;

Pgb - Resetable -- MAC statistics;

Cinr - RO -- PHY statistics;

Rssi - RO -- PHY statistics;

Fofs - RO -- PHY statistics;

Corb - RO -- PHY statistics;

txmode Set to continuous transmit mode.

5.2.3 deRegisterSs

The deRegisterSs command forces the base station to deregister a subscriber.

Table 34: CLI - Interfaces Command: advancedConfig (debug mode)

Command

Parameter/Description

deRegisterSS

<MAC_Address>

Yes

Example:

AN100U#> deRegisterSs ?

<MAC_Address> - <0 -- 00:09:02:03:00:f6; 1 -- 00:09:02:03:03:ab> Either

enter a valid

Wireless SS MAC address or enter an index number from the

help

message to select one.

Yes - Confirmation to proceed.

AN100U#> deRegisterSS 0

The Subscriber 00:09:02:03:00:f6 will be de-registered. Continue? (press

'Y' to confirm, any other key to Cancel.)

AN100U#>

5.2.4 interfaces

The interfaces command is used to view and configure the front panel Data and

Management (Mgmt) Ethernet ports and the wireless interface. Additional commands

are available in debug mode.

Table 35: CLI - Interfaces Command: advancedConfig (debug mode)

Command

Parameter/Description

set

AdaptModEn Enable/disable adaptive modulation. Enabling this control disables

the default modulation settings.

0 -- disable

1 -- enable

default Reset all parameters into default values.

DLModDefault Select the default modulation and coding rate for the downlink

channel. This value is used only when Adaptive Modulation is disabled. When

Adaptive Modulation is disabled the base station will transmit data only using the

selected modulation/coding.

0 - BPSK(1/2)

1 - QPSK(1/2)