User's Manual

User
AN-100U/UX Base Station
Manual
70-00058-01-04 Proprietary Redline Communications © 2010 Page 91 of 136 April 19, 2010
Table 36: CLI - Interfaces Command: ethernet
Command
Parameter/Description
4: Operate at 100Base-T full duplex mode only.
Intra-SectorL2Forwar Establish a virtual private network at layer 2 between any
number of subscriber CPEs in single sector.
0: Disabled - base station will not accept traffic resubmitted to the Ethernet
port
1: Internal - base station creates a service flow to provide transparent
tunneling for higher-layer protocols
2: External - base station allows an external switch to forward VLAN traffic
back through the (originating) base station Ethernet port and over the
wireless.
show
Display the Ethernet data port configuration.
Example:
AN100U(interfaceEther ->)#> set
IntSep - 0 -- Via Data port; 1 -- Via Management port.
DataDuplex - 0 -- Auto Detect; 1 -- 100Mbps/Full Duplex; 2 --
10Mbps/Full Duplex; 3
-- 100Mbps/Half Duplex; 4 -- 10Mbps/Half Duplex.
MgmDuplex - 0 -- Auto Detect; 1 -- 100Mbps/Full Duplex; 2 --
10Mbps/Full Duplex; 3
-- 100Mbps/Half Duplex; 4 -- 10Mbps/Half Duplex.
Intra-SectorL2Forwar - 0 -- Disabled; 1 -- Internal; 2 -- External.
default - to reset all parameters into default values.
Yes - Confirmation to proceed.
AN100U(interfaceEther ->)#> show
Structure --- <<Ethernet Interface Configuration>>
IntSep:.......................ViaManagementport(1)
DataDuplex:...................AutoDetect(0)
MgmDuplex:....................AutoDetect(0)
Intra-Sector L2 Forwarding:...Disabled(0)
Table 37: CLI - Interfaces Command: management
Command
Parameter/Description
set
LocalIp Enter the static base station network IP address.
LocalMask Enter the base station subnet address mask.
DefGateway Enter IP address of default gateway on local Ethernet segment.
DhcpEnable
0: Manually enter the following IP parameters
1: Have the base station obtain its IP address from a DHCP server.
ToDIP Enter the IP address of an the SNTP server.
TimeZoneHour Enter the offset (hours) from GMT.
TimeZoneMinute Enter the offset minutes (fraction) from GMT.
DayLightSavings Enable automatic time change for daylight savings.
0: Disabled
1: Enabled
SysLogIP Enter the IP address of the System Log server.
DhcpServIPUsr Specify the IP address of a DHCP server. The base station
forwards all subscriber DHCP requests to this address.
DhcpType Set the DHCP relay type.
0: Base station forwards all subscriber DHCP requests to the DHCP server
that the base station used to obtain its IP address.
1: Subscriber to use the specified DHCP server. Use DhcpServIPUs to specify
the DHCP server to be used by subscribers.
MgmtVLAN Enable or disable management using VLAN tagged traffic.
0: Disable tagged management.