User's Manual

User
AN-100U/UX Base Station
Manual
70-00058-01-04 Proprietary Redline Communications © 2010 Page 92 of 136 April 19, 2010
Table 37: CLI - Interfaces Command: management
Command
Parameter/Description
1 Enable tagged management.
VlanId Enter the VLAN ID (VID) for the management VLAN.
default Restore all settings to factory default values.
show
Display the Ethernet management port configuration.
Example:
AN100U(mgmConfig ->)#> show
Structure --- <<Management Configuration>>
DHCP Relay Agent Params IP, ToD & VLAN params
------------------------------------- -------------------------------------
Enable:..............StaticIP(0) LocalIP:...........192.168.20.96
DhcpServIPUsr:.....192.168.20.52 LocalMask:.........255.255.255.0
Type:.......Use_DhcpServIpUsr(0) DefGateway:.......192.168.20.250
ToDIP:.............172.25.100.45
TimeZoneHour:.................-4
TimeZoneMinutes:...............0
DayLight Saving:......Enabled(1)
SysLogIP:..........192.168.20.73
Management VLAN:...........No(0)
VLAN ID:.......................0
Table 38: CLI - Interfaces Command: wireless
Command
Parameter/Description
set
ChannelBandwidth*
5 -- 7 Mhz
6 -- 3.5 Mhz;
CyclicPrefix* (phyCp)
0 -- 1/32
1 -- 1/16
2 -- 1/8
3 -- 1/4
Default restore all settings to factory default values.
DefaultUlSfEnable*
0 -- disable default uplink service flows
1 -- enable default uplink service flows
Note: Default DL service flows are permanently enabled.
MacAdaptiveTDD
0 -- Disabled
1 -- Enable
MacAirInterfaceStatus
0 -- disable RF
1 -- enable RF
MacDLRatio downlink ratio (25 - 80)
MacFrmDuration
0 -- 2.5
1 -- 4
2 -- 5
3 -- 8
4 -- 10
5 -- 12.5
6 -- 20
MacMaxDistance* maximum distance to any subscriber