User's Manual

User
AN-100U/UX Base Station
Manual
70-00058-01-04 Proprietary Redline Communications © 2010 Page 94 of 136 April 19, 2010
5.2.5 ipAddress
The ipAddress command is used to view and configure the base station IP address
parameters.
Table 39: CLI - IP Address Command
Command
Parameter/Description
set
Modify the base station network IP settings.
Address: <IP Address> Enter new IP address.
XXX.XXX.XXX.XXX
Mask: <IP Mask> Enter new Netmask value.
XXX.XXX.XXX.XXX
Dhcp: Enable or disable DHCP support.
0: - Static address
1: - DHCP allocated address.
Gateway < Default gateway> Enter new gateway address. Requires
confirmation to proceed.
show
Display all IP address information.
Structure --- <<SC IP Address Data>>
Address:......................192.168.20.94
Mask:.........................255.255.255.0
Dhcp:.........................StaticIP(0)
Gateway:......................192.168.20.250
5.2.6 monitor
The monitor command is used to view a dynamically updated screen of statistics for the
base station.
Table 40: CLI - Monitor Command
Command
Parameter/Description
monitor
Dynamic display of base station statistics values. For example:
MacFrameNumber: 11296
MacStations: 5
MacUlServiceFlows: 3
MacDlServiceFlows: 3
MacDlUsage: 7 %
MacUlUsage: 3%
MacCrcErrors: 0
MacSymErrors: 0
MacDlSdus: 3590
MacUlSdus: 1889
MacDlMpdus: 3574
MacUlMpdus: 2378
MacDlSecMgm: 1353730
MacUlSecMgm: 1346805
MacDlDefaultSdus: 0
MacUlDefaultSdus: 0
MacFpc: 9
MacBwr: 1928
MacPgb: 0
PhyCinr: 31.5 dB
PhyRssi: -12.0 dBfs
PhyFofs: 183 Hz
PhyCorb: 0
5.2.7 reboot
The reboot command is used to remotely reset the base station.
Table 41: CLI - Reboot Command
Command
Parameter/Description
reboot
Reboot the base station. Confirmation is required.