User's Manual

AN-30e
user manual
70-00035-01 Proprietary Redline Communications © 2004 November 2004
Page 35 of 104
5.3 System Status
Click System Status in the menu to view system information and Ethernet and
wireless statistics.
Figure 13: System Status Screen
5.3.1 General Information:
System Name: Displays the user-specified name for the local terminal.
Software Version: Displays the detected software version in use.
RF Link Established: Displays the status of the wireless link.
Yes - RF link is established.
No - RF link has not been established.
Uncoded Burst Rate [Mb/s]: Displays the uncoded burst rate for the link.
Master-mode: Displays the user-specified operating mode of the terminal.
Yes: System is configured as a sector controller.
No: System is configured as a subscriber station.
Important
: Only one terminal must be designated Master on each wireless link.
RF Channel Frequency: Displays the user-specified channel center frequency.
Tx Power: Displays the user-specified transmit power level.
Cable Attenuation: Displays the measured attenuation level for the 800 MHz signal
over the IF cable.