User's Manual

AN-30e
user manual
70-00035-01 Proprietary Redline Communications © 2004 November 2004
Page 38 of 104
5.5 Configure System
Click Configure System in the menu to view and adjust configuration settings for
general system identification, Ethernet, and the wireless interface.
Important: Ensure that all fields on the System Configuration Screen are filled out
properly for local and subscriber terminals. Errors in these fields can result in the
inability to establish a communication link. Please read carefully to ensure a quick,
trouble-free deployment.
5.5.1 Ethernet Configuration:
The IP address information must be set properly before the terminal is connected to
the local Ethernet network, otherwise, address conflicts may occur with other devices
on the network.
Figure 15: System Configuration Screen - Ethernet Settings
System Name: User-specified name for the local terminal. Enter any combination of
up to 20 letters and numbers.
System Details: User-specified system description for the local terminal. Enter any
combination of up to 20 letters and numbers.
IP address: User-specified IP address for this terminal. The factory default address is
192.168.25.2.
IP Subnet Mask: User-specified IP subnet mask. The factory default mask is
255.255.255.0 (Class C subnet).
Default Gateway Address: User-specified IP address of the default gateway on the
local Ethernet segment.
Flow Control Enable: Check this box to enable flow control on the terminal.