User's Manual

AN-30e

user manual

Page 40 of 104

Figure 17: SNMP Configuration Screen

SNMP Configuration: The list of defined communities is displayed in the

Community Name table.

Edit: Select a community from the pull down menu and click the Edit button to

modify an existing community. The Community Configuration/Trap Configuration

screen is displayed.

Delete: Select the community from the pull down menu (bottom left of screen) and

then click the Delete button to delete that community. Note that it is not possible to

delete the public SNMP community, but the access level can be changed.

Add Community: Click the Add Community button to add a new community. The

Community Configuration/Trap Configuration screen is displayed.

Add Community: To add a new community, click Add Community button. The

Community Configuration/Trap Configuration screen is displayed.

Community Configuration:

Community Name: The SNMP community name.

Community Access - Read: Check the Read box to grant read access permission to

members of this community. Uncheck this box ( ) to deny read permission.

Community Access - Write: Check this box

to grant write access permission to

members of this community. Uncheck this box (

) to deny write permission.

Trap Configuration

Trap Enable: When the SNMP Agent in the terminal detects an error condition, a

message known as a trap is sent. A Trap Host is an IP system/server that is set up to

receive SNMP trap messages. Checking this option enables sending traps.

Trap Destination (IP Addr. 1): Enter the IP address of the Trap Host in dotted

decimal format. At least one (1) IP address is required.

Trap Destination (IP Addr.2): Enter the IP address of the Trap Host in dotted

decimal format. This address may be left blank.

Trap Destination (IP Addr. 3): Enter the IP address of the Trap Host in dotted

decimal format. This address may be left blank.

Trap Destination (IP Addr. 4): Enter the IP address of the Trap Host in dotted

decimal format. This address may be left blank.