User's Manual

AN-30e
user manual
70-00035-01 Proprietary Redline Communications © 2004 November 2004
Page 69 of 104
Chapter
7
7
7
D
D
i
i
a
a
g
g
n
n
o
o
s
s
t
t
i
i
c
c
s
s
a
a
n
n
d
d
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
Troubleshooting can be performed using the front panel LEDs and the host
computer/server connected locally or remotely to the terminal.
Before troubleshooting using the front panel LEDs, check that all cables are securely
attached. Also, verify that all fields on the System Configuration page are correct for
both communicating systems. Entry errors in these fields may cause the terminal to be
unable to establish a communication link.
This section provides basic diagnostic and troubleshooting procedures to help solve
problems that may occur with the system. If, after reading this section, you are unable
to get the system operating properly, please contact your local Redline representative.
Include the model name and serial number of the system (located on the back of the
terminal) in your communications.
7.1 Factory Default Settings
The following parameters are the factory default setting for the terminal. These
settings are restored when a long-reset is activated.
Table 30: Factory Default Settings
Section Item Factory Default Setting
System User Name admin
Password admin
Ethernet IP Address 192.168.25.2
Subnet Mask 255.255.255.0
Gateway 0.0.0.0
Wireless RF Channel 5.765 GHz
Tx power 14 dBm