Manualshelf

User's Manual

ManualsBrandsRedline Communications ManualsElectronicsAN-50e/AN-30e System w/ T-58e Radio
81828384858687888990
AN-30e
user manual
70-00035-01 Proprietary Redline Communications © 2004 November 2004
Page 89 of 104
Table 44: CLI - System Status
Command Description
the air
swver The operating software version
sysname Identifies the local terminal
txpower The actual current transmit power level
wrxpkt The number of successful wireless packets received over
the air
wrxpktd The number of wireless packets received with errors over
the air
wrxpktr The number of wireless packets retransmitted over the air
wtxpkt The number of wireless packets successfully transmitted
over the air
wtxptd The number of transmitted packets discarded
wtxpktr The number of wireless packets retransmitted over the air
System Configuration
Table 45: CLI - System Configuration
Command Description
adaptmod Enables Adaptive Modulation mode.
buzzer Specifies whether the antenna buzzer is enabled - defaults
to voltage.
chgver Change the operating software version
encrypt Specifies whether over-the-air data encryption is enabled
encryptkey Enter the subscriber terminal MAC address if encryption is
enabled
flowctrl Specifies if flow control is enabled on the Ethernet port
gateway The IP address of the default router
http Specifies whether configuration over HTTP is enabled
ipaddr The IP address used by the local terminal
ipmask The IP Subnet Mask used by the local terminal
llmod Specifies if the link length is calculated automatically or
manually. Available options: off for auto and on for manual.
llmu The current measurements units used for the link length.
Available options: off for miles and on for kilometers.
ll Actual length of the path that the wave travels.
macaddr The Ethernet MAC address used by the local terminal
master Displays whether the system is operating as the sector
controller. Important
: For each set of Systems, only one
terminal must be designated Master.
modreduct Used when AdaptMod is disabled.
radio Specifies whether radio transmission is enabled
reboot Reset all statistics and reboot the terminal
rfchannel Available channel options: 1, 1A, 2, 2A, 3, 3A, 4, 4A, 5.