User's Manual

AN-30e
user manual
70-00035-01 Proprietary Redline Communications © 2004 November 2004
Page 92 of 104
TDM General Commands
Form of command is:
tdm set command [param1] [param2] [param3]
Table 46: CLI - TDM General Commands
CLI Command Description
clock CLK_IND Clocking mode on E1 module.
fanstate FAN Status of fan.
gateway IPGATEWAY IP address of the default gateway.
hostname HOST Hostname of the E1 module.
ipaddr IP The IP address of the E1 module.
ipmask IP Network mask.
key Option key (permitted line types, number of lines, user data)
on the E1 module.
keyidlecode IDLECODE Idle code for unused timeslots on all of the serial interface
ports.
line LINE_TYPE Line type on the E1 module (if permitted by the option key).
0=T1, 1=E1
showactivebundles Total active bundles and list the IDs of those bundles.
showgen CONFIG General configuration parameters from running or startup
config.
softver Coded software version.
syncon SYNC_ON The serial interface port to be used as clocking reference.
vlandata VID_DATA The VLAN ID used to tag all ingress traffic at the data port
of the AN-30e.
vlanvoice VID_VOICE The VLAN ID used to tag all traffic from the E1 ports of the
AN-30e.
TDM Set and Get operations
The get operation returns values from the running configuration. The set operation
applies changes only to the temporary configuration. Use the 'tdm test' command to
try the settings for five minutes or the 'tdm save' command to save the changes
permanently.
All commands are of the following format:
tdm set operator SN <optional parameters>
tdm get operator SN command
Table 47: CLI - TDM Set and Get Commands
CLI Command Description
get Retrieve the parameter value from a running configuration.
set Modify the specified parameter value in the temporary
configuration.
show List all parameter values of the command category.