Manualshelf

User's Manual

ManualsBrandsRedline Communications ManualsElectronicsAN-50e/AN-30e System w/ T-58e Radio
31323334353637383940
AN-50e
user manual
70-00033-02 Proprietary Redline Communications © 2004 November 2004
Page 36 of 96
The following sections list parameters that must be set before the terminal is
connected to the Ethernet port, or the IF cable is connected to the transceiver.
5.5.2 Ethernet Settings
The network address settings for the every terminal must be configured before the
terminal can be connected to the local area network. Only the following Ethernet
settings need to be adjusted at this time:
IP address: Enter the IP address for this terminal. Each System must also have
a unique IP address.
IP Subnet Mask: Enter the IP subnet mask.
Default Gateway Address: Enter the IP address of the default router or
gateway on the local Ethernet segment.
Ethernet Mode: Select the operating mode of the Ethernet port (auto-
negotiate, 10Base-T, or 100Base-T).
5.5.3 Wireless Settings
The wireless parameters must be set properly before the terminal is enabled to
transmit -- otherwise it may cause interference to other high frequency devices
operating in the vicinity. See section 6.3.1: Configure System on page 49 for more
details.
Master System Settings (Master Mode )
The following settings should be set for the system operating as master:
Master Mode: Check this box to enable this system to operate as the master
system. Only one terminal must be designated Master.
RF Freq. [MHz]: Enter the channel center frequency of the system.
TX Power [dBm]: Enter the default tx power level (dBm). Refer to section 8.3:
Antenna and Power Specifications on page 82.
DFS Action: Select the mode of operation for DFS on this terminal.
Important: Where specified by local regulations, the DFS feature will always be
enabled. The default selection will be Chg Freq.
DFS Antenna Gain: Enter the antenna gain (dBm). This value must be set to
match the system antenna.
ATPC Enable: Check this box to enable the Automatic Transmit Power
Control function. This feature will automatically adjust the power level of the
remote-end system.
Adaptive Modulation: Check this box to enable adaptive modulation mode.
Radio Enable: Check
this to enable the radio transmitter.