User's Manual

AN-50e
user manual
70-00033-02 Proprietary Redline Communications © 2004 November 2004
Page 87 of 96
8.4 CLI Interface
8.4.1 Console (RS-232) Port
All operator communications with the terminal may be made using a direct
connection to the serial Console Port on the back of the terminal. This section
describes the procedures for configuring and operating the terminal via the
Console Port using the command line interface (CLI).
Connect a PC/Terminal to the terminal's serial port DB9 connector using a cross-
connect or null modem cable (DB9 female-female). Set the PC/Terminal to
emulate a VT-52 or VT-100 terminal, using the following port settings: Bits Per
Second: 9600; Data Bits: 8; Parity: None; Stop Bits: 1; Flow Control: Hardware
The following table lists the terminal 9 PIN D-SUB male connector pinout.
Table 33: Console (RS-232) Port Pinout
Pin Name RS232 V.24 Description
2 RXD BB 104 Receive Data
3 TXD BA 103 Transmit Data
5 GND AB 102 System Ground
V.24 column is ITU-TSS V.24 circuit name.
RS232 column is RS232 circuit name.