User's Manual

AN-50e

user manual

Page 9 of 96

1.4 FCC Notice

1. The System is used as a fixed wireless Ethernet bridge that requires

professional installation with specified antennas and output power levels

certified under the FCC Grant for System for point-to-point mode of

operations.

2. FCC RF Exposure Requirements:

T-54 and T-58: The antenna(s) used for these radios must be fixed-mounted on

outdoor permanent structures. In point-to-point applications each antenna must

be separated from all persons by a distance of at least 2.5 meters. In point-to-

multipoint applications each antenna must be separated from all persons by a

distance of at least 20 centimetres.

T-58e: The antenna(s) used for this radio must be fixed-mounted on outdoor

permanent structures. In point-to-point applications each antenna must be

separated from all persons by a distance of at least 3.1 meters. In point-to-

multipoint applications each antenna must be separated from all persons by a

distance of at least 20 centimetres.

3. The System is certified by the FCC and Industry Canada with the 5.4/5.8 GHz

directional and parabolic antennas listed in the Appendix of this manual.

4. For fixed, point-to-point mode of operations, the transmitting antennas must be

directional as specified in this User Manual; the use of omni-directional

antenna is prohibit for point-to-point operation.

5. For Class A Unintentional Radiators: This equipment has been tested and

found to comply with the limits for a Class A digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference

at their own expense.

6. Warning: Changes or modifications not expressly approved by Redline

Communications Inc. could void the user's authority to operate the equipment.