User's Manual
Table Of Contents
- Contact Information
- UL Information
- LIST OF TABLES
- Getting Started
- Important Safety Information
- Important Service Information
- Unpacking the AN-50 System
- AN-50 System Mode of Operation
- The AN-50 Terminal at a Glance
- AN-50 System Installation
- System Configuration and Operation Via the Web Interface
- Diagnostics and Troubleshooting
- Appendix
AN-50 System User Manual
Redline Communications …..solving the first mile challenge.
B) Wireless Status Indicators
The Wireless portion of the front panel features two LEDs; Link and Signal, as shown
below.
Figure 3: Front Panel - Wireless
Link – For a slave terminal, the “Link” LED lights solid green when the radio link to the
master terminal is established and the LED will turn off if the link is lost. For a master
terminal, the LED lights solid green when at least one radio link to any of the provisioned
slaves is established and will turn off if all links are lost.
Signal – The “Signal” LED lights solid green if the system, the link (the (links for a
master) and the provisioned connections all operate within configured parameters. See
section 9.1.4 on page 49 for a detailed description.
C) Ethernet Status Indicators
The Ethernet portion of the front panel display comprises four main LEDs; Link, 100, FD
and Col, as shown below.
Figure 4: Front Panel – Ethernet
Link – The “Link” LED illuminates solid green when the Local Area Network (LAN)
connection is established, and there is no traffic. The Link LED will flash when the Local
Area Network (LAN) connection is established, and there is traffic.
Page 16 of 76