User's Manual
Table Of Contents
- Contact Information
- UL Information
- LIST OF TABLES
- Getting Started
- Important Safety Information
- Important Service Information
- Unpacking the AN-50 System
- AN-50 System Mode of Operation
- The AN-50 Terminal at a Glance
- AN-50 System Installation
- System Configuration and Operation Via the Web Interface
- Diagnostics and Troubleshooting
- Appendix
AN-50 System User Manual
Redline Communications …..solving the first mile challenge.
The AN-50 terminal may also be connected directly to the host computer, as shown in
Figure 11. In this configuration, a straight-through CAT 5/UTP cable is required to
complete the connection.
Figure 11: AN-50 Terminal Connected To Host Computer
To help you establish other implementations that are not addressed in this manual,
Figure 12 provides an illustration of the pinout for the AN-50 terminal LAN interface.
Warning: do not connect a telephone cable to the AN-50 LAN interface, as this will
damage the terminal.
Jack Pin Function
1 Rx +
2 Rx -
3 Tx +
6 Tx -
Figure 12: AN-50 Terminal LAN Ethernet Port Pinout
Now connect the AC cord to the 110/220/240 VAC outlet and turn the terminal on using
the toggle switch at the rear of the unit. The system “Pwr” LED should illuminate green to
Page 24 of 76