User's Manual

AN-50 System User Manual
Redline Communications …..solving the first mile challenge.
8
8
.
.
S
S
y
y
s
s
t
t
e
e
m
m
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
a
a
n
n
d
d
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
V
V
i
i
a
a
t
t
h
h
e
e
W
W
e
e
b
b
I
I
n
n
t
t
e
e
r
r
f
f
a
a
c
c
e
e
All operator communication with the AN-50 terminal is achieved over the Ethernet port
using hypertext transfer protocol (HTTP). This offers the advantage of allowing the
operator to access and control the AN-50 terminal remotely from any geographical
location, providing there is access to the Internet. This section describes the procedures
for configuring and operating the AN-50 terminal via the web interface. All screens and
explanations refer to both PTP / PMP modes of operation unless otherwise specified.
Note for the initial set-up, the operator must connect the host computer locally to the AN-
50 terminal as shown in Figure 11.
Log on to the AN-50 General Information home page from a web browser. Microsoft
Internet Explorer is recommended, as it enables context help when the cursor is
positioned over any item.
Enter the system’s default IP address - http://192.168.25.2
.
Entering the IP address above will call up the General Information page, via the ID /
Password dialog as shown in Figure 14 below. The items on this page are described in
detail in section 8.4 below. If the General Information page is not accessible, check for
possible text entry errors; otherwise refer to the Diagnostics section of this manual
(section 9) for further assistance.
It will be necessary to enter a valid user name and password. Note that a valid
Administrator password is required to enter any of the following pages:
Page 27 of 76