User's Manual
Table Of Contents
- Contact Information
- UL Information
- LIST OF TABLES
- Getting Started
- Important Safety Information
- Important Service Information
- Unpacking the AN-50 System
- AN-50 System Mode of Operation
- The AN-50 Terminal at a Glance
- AN-50 System Installation
- System Configuration and Operation Via the Web Interface
- Diagnostics and Troubleshooting
- Appendix
AN-50 System User Manual
Redline Communications …..solving the first mile challenge.
• System Config
• System Password
• ID Config / Status
• Upload Software
• Reset button on System Status
An example of the user name and password screen is shown in Figure 14. There are 2
users – “user” and :admin”. The default value (set at the factory) for both the user name
and password for the Administrator is "admin". This login allows access to all screens.
The default value (set at the factory) for both the user name and password for the User
is "user". This login denies access to the System Config, System Password, ID Config /
Status, Upload Software and Reset Button on System Status screens. Refer to the
System Password screen to change the password for future sessions. If the password is
changed, record it in a secure location for future reference. Note that the user name
cannot be changed from "admin".
Figure 14: User Name And Password Dialog
The main menu on the left includes the following links:
•
General Information
• System Status
• System Log
• System Config
• System Password
• ID Browser
• ID Config / Status
•
Upload Software
The General Information page does not accept input from the user. Data shown on this
page may be modified via the Configuration page.
Page 28 of 76