User's Manual
Table Of Contents
- Contact Information
- UL Information
- LIST OF TABLES
- Getting Started
- Important Safety Information
- Important Service Information
- Unpacking the AN-50 System
- AN-50 System Mode of Operation
- The AN-50 Terminal at a Glance
- AN-50 System Installation
- System Configuration and Operation Via the Web Interface
- Diagnostics and Troubleshooting
- Appendix
AN-50 System User Manual
Redline Communications …..solving the first mile challenge.
Figure 16: ID Config / Status
ID Properties:
ID: Select the channel ID to be configured, deleted or displayed for the system in which
you are interested. In order to locate the proper ID number use the ID Browser described
in section 8.3.
ID Screen Buttons:
Configure: Calls the Link Configuration screen (see section 8.2.1) for the selected ID.
Delete:
Deletes the selected ID.
Statistics: Displays the Link / Connection Status screen (see section 8.2.2) for the
selected ID.
New ID: Adds a new ID by calling the Link Configuration screen (see section 8.2.1).
Save IDs: Saves the entire ID table in Flash.
Clear All IDs: Clears all IDs from the FLASH. Note: This process cannot be undone.
8.2.1. Link Configuration
This screen is displayed through the ID Config / Status screen by clicking the Config
button. Please note that this screen will be active only on the AN-50 operating in PMP /
PTP master mode. The fields in the Link Configuration screen need to be filled out for
each individual subscriber station.
Page 33 of 76