User's Manual
Table Of Contents
- Contact Information
- UL Information
- LIST OF TABLES
- Getting Started
- Important Safety Information
- Important Service Information
- Unpacking the AN-50 System
- AN-50 System Mode of Operation
- The AN-50 Terminal at a Glance
- AN-50 System Installation
- System Configuration and Operation Via the Web Interface
- Diagnostics and Troubleshooting
- Appendix
AN-50 System User Manual
Redline Communications …..solving the first mile challenge.
Peer MAC: Shows the MAC address of the subscriber station
Active: "Yes" indicates the RF link with the remote terminal is established. "No"
indicates there is no RF link to the remote terminal. This indicator is correlated to the
Wireless Link LED of the slave AN-50.
Link up time: Specifies the time since the unit was started.
Link Lost Count: Specifies how many times the link was lost since system was
started.
Status Code: A code shown as a hex number indicating the condition of the RF
components within the AN-50 terminal and T-58 Transceiver.
Configured Connections: Shows the total number of connections configured for this
link. For the current AN-50 revision the system will always display one (1) connection.
Link Status Downlink / Uplink:
Burst Rate [Mb/s]: Indicates for this wireless link the current Tx burst rate used by the
master (downlink) and by the slave (uplink) ..
RSSI [dBm]: Indicates the average received signal strength (RSSI) at slave (downlink)
and master (uplink).
SINADR [dB]: Indicates the average signal to interference noise and distortion ratio
(SINADR) at slave (downlink) and master (uplink). The ratio is based on the digital
information provided from the output of the A/D converter and includes the effects of the
AGC.
Link Statistics Downlink / Uplink:
Blocks Total: Shows the total blocks transmitted from master to slave (downlink) and
from slave to master (uplink). Note that, in order to utilize efficiently the wireless
bandwidth and to allow tight QoS control, the system fragments and concatenates
Ethernet packets in blocks, where blocks are then transmitted over the air.
Blocks Retransmitted: Shows the total blocks retransmitted.
Blocks Discarded: Shows the total blocks lost
Packets Discarded: Indicates the total number of packets discarded due a full buffer full
Packets Transmitted: Indicates the total number of packets transmitted.
Packets Received: Indicates the total number of packets received.
Page 36 of 76