User's Manual

AN-50 System User Manual
Redline Communications …..solving the first mile challenge.
8.8. System Logs
The System Logs page, shown in Figure 26 below, provides a list of the last forty
messages recorded by the AN-50 terminal, describing either system activity or errors
that have occurred.
Figure 26: System Logs Screen
The logs will also indicate if the following transactions were successfully completed:
• Save Configuration – Under the Configuration screen.
• Upload
– Under the Upload Software screen.
• Change Password
– Under the System Password screen.
• Send Options Key
The following table provides a brief description of the key messages recorded in the logs
by the system:
Log Message Description
100-Parameters loaded successfully! All system parameters have been successfully
downloaded.
101-Firmware configuration OK! The onboard firmware configuration has been
properly set up.
102-Ethernet port configured! The Ethernet port has been properly configured and is
operational.
103-Parameters saved successfully! The latest configuration parameters have been
successfully saved into the system memory.
104-Upgrade OK! The software upgrade process completed
successfully.
105-Password changed successfully! The system password was successfully changed.
106-Firmware programmed OK! The firmware was successfully programmed.
107-Statistics initialized! Reset of statistics was successful.
108-Version control loaded successfully! Software version control data was successfully
loaded.
109-Options Key activated! Product Options Key was accepted.
110-Options Key already used! The Product Options Key was not accepted because
it was already used once. Contact your local Redline
representative.
201-EEPROM corrupted. Def. param.
loaded!
The memory area containing the system configuration
has been corrupted. Default parameters loaded.
202-Error while saving parameters! The latest configuration parameters have not been
successfull
y
saved. In this case, re
p
eat the save
Page 44 of 76