User's Manual

RedCONNEX
TM
AN-80i
PTP & PMP User Manual
70-00072-01-04-DRAFT Proprietary Redline Communications © 2007 May 7, 2007
Page 59 of 91
Table 12: CLI - Root Mode Commands
PTP PMP Command Description
√ √
?
Use the '?' character to display help for any command or mode.
Example
: From the root directory, enter the following command to
list all parameters that can be changed using the 'set' command:
set ?
√ √
CTRL-Z
Return to root mode.
Cancel command entry (alternative to backspace delete).
√ √
exit
Return to parent node / mode.
all (exit all) Return to root mode.
√ √
logout
Terminate this telnet session. May be entered from any mode.
5.2 Connecting with Telnet
To connect to the AN-80i, open a Telnet session to the IP address of the AN-80i. On a
Windows™ PC, open the Run command and type 'telnet' followed by the IP address of
the AN-80i. When the command prompt screen appears, login to the AN-80i. The AN-
80i may now be controlled using a set of CLI commands.
Figure 35: CLI - Connecting via Telnet
The system will logout users automatically if no commands are received (idle) for five
minutes. To exit immediately from the CLI, type the following command:
logout [ENTER]