User's Manual

RedCONNEX
TM
AN-80i
PTP & PMP User Manual
70-00072-01-04-DRAFT Proprietary Redline Communications © 2007 May 7, 2007
Page 60 of 91
5.3 CLI Command Set
5.3.1 Chgver
Use the chgver command to change the software version to loaded when you reboot the
AN-80i. Also see the Get command 'swver'.
Table 13: CLI - chgver
PTP PMP Parameter/Description
√ √ Enter this command to toggle between software versions. The setting will
alternate between the two banks of memory (no parameters).
chgver <Enter>
5.3.2 Clear
Use the clear command to delete all IDs from an ID table.
Table 14: CLI - clear
PTP PMP Parameter/Description
√
clear
idtable - Clear all the IDs
5.3.3 Del
Use the del command to delete a specific ID.
Table 15: CLI - del
PTP PMP Parameter/Description
√
del
<id> - [id number]
5.3.4 Enable
Use the enable command to re-enable a specific ID (that was disabled).
Table 16: CLI - enable
PTP PMP Parameter/Description
√
enable
<id> - [id number]