User's Manual

RedCONNEX
TM
AN-80i
PTP & PMP User Manual
70-00072-01-04-DRAFT Proprietary Redline Communications © 2007 May 7, 2007
Page 62 of 91
Table 17: CLI - get
√ ldlbr: Downlink burst rate.
√ ldldblk: Downlink discarded blocks counter.
√ ldllfr: Downlink lost frames counter.
√ ldlrblk: Downlink retransmitted blocks counter.
√ ldlrssi: Downlink RSSI.
√ ldlsnr: Downlink SINADR.
√ llostc: Link lost Connection counter counter.
√ lrcon: Number of link registered Connections.
√ lscode: Link status code.
√ lulblk: Uplink total blocks counter.
√ lulbr: Uplink burst rate.
√ luldblk: Uplink discarded blocks counter.
√ lullfr: Uplink lost frames counter.
√ lulrblk: Uplink retransmitted blocks counter.
√ lulrssi: Uplink RSSI.
√ lulsnr: Uplink SINADR.
√ luptime: Link up-time.
√ regconn: Number of configured Connections.
√ regstations: Number of configured stations.
√ uldpkt: Uplink discarded packets counter.
√ ulrpkt: Uplink Rx packets counter.
√ ultpkt: Uplink Tx packets counter.
√ werxpkt: Wireless Eth Rx packets counter.
√ werxpktdis: Wireless Eth Rx discarded packets counter.
√ werxpkterr: Wireless Eth Rx packets with errors counter.
√ wetxpkt: Wireless Eth Tx packets counter.
√ wetxpktdis: Wireless Eth Tx discarded packets counter.
√ wetxpkterr: Wireless Eth Tx packets with errors counter.
5.3.6 Load
Use the load command to load an ID table from non-volatile memory.
Table 18: CLI - load
PTP PMP Parameter/Description
√
load
idtable - Load all IDs from saved (FLASH) memory.