User's Manual

RedCONNEX
TM
AN-80i
PTP & PMP User Manual
70-00072-01-04-DRAFT Proprietary Redline Communications © 2007 May 7, 2007
Page 68 of 91
Table 23: CLI - set
√
√
snmptraplink: Enable or disable sending an SNMP trap message for each
link-up and link-down event.
<setting> - [on | off]
√ snmptraps: Status of the SNMP traps flag.
<mode> - [on | off]
√ snmptraps: Enable or disable sending all SNMP traps.
<setting> - [on | off]
√ √
sntp: SNTP enable setting.
off - Disable SNTP protocol support.
on - Enable SNTP protocol support.
√ √
sntpip: Enter the SNTP server IP address. Valid only if sntp is enabled.
√
√
sntppoll: Enter the interval to synchronize with the sntp server.
<polltime> - SNTP polling interval [hours].
√ sstoss: Status of packet routing between SSs.
<id> - [id number]
<mode> - <on/off> - Route broadcast packets from SS to SS
√ √
syscontact: Enter additional descriptive details about this AN-80i. The
description can be any combination of up to 20 letters and numbers.
√ √
sysdescr: Enter descriptive details about this AN-80i. The description can be
any combination of up to 20 letters and numbers.
√ √
sysloc: Enter descriptive details about the location of this AN-80i. The
description can be any combination of up to 20 letters and numbers.
√ √
syslog: Syslog enable setting.
off - Disable syslog server protocol support.
on - Enable syslog server protocol support.
√ √
syslogip: Enter the syslog server IP address. Valid only if syslog is enabled.
√ √
sysmode:
PTP Operation
:
ptpsector controller - The sector controller (base station) begins
transmitting automatically; sending poll messages to locate the
remote subscribers (ptpsubscriber).
ptpsubscriber - Subscriber waits passively, monitoring the selected
channel(s) until polled by the ptpsector controller (base station).
PMP Operation
:
pmpsc - The sector controller (base station) begins transmitting
automatically; sending poll messages to locate the remote
subscribers (pmpss).
pmpss - Subscribers wait passively, monitoring the selected channel(s)
until polled by the pmpsc (sector controller).
<SysMode> - [pmpss | pmpsc]
√ √
sysname: Enter the name for this AN-80i. The name can be any combination
of up to 20 letters and numbers.
√ √
telnet: Enable or disable the Telnet port. If the Telnet port is disabled, it will not
be possible to use the CLI interface.
off - Disable
on - Enable
Changes to this field are effective only following reboot.