User's Manual

RedCONNEX

AN-80i

PTP & PMP User Manual

Page 41 of 91

4.4 PMP Screens

This section describes the configuration screens used to setup a PMP deployment.

4.4.1 Configuration Screen

Click Configure System in the menu to view and adjust configuration settings for general

system identification, Ethernet, and the wireless interface (partial screen shown below).

The highlighted fields are specific to PMP deployments.

Ethernet Settings

Figure 22: PMP - Ethernet Settings

Polling Interval: Enter the SNTP polling interval (hours).

Mgmt. Tag Enable: Check this box to enable VLAN tagged traffic.

The Mgmt Tag Enable setting is disabled (factory default) when shipped from the factory

or following a long-reset operation. In this mode the sector controller and subscriber

stations can be managed through the local Ethernet port using untagged traffic. Over-the-

air management is possible only after creating a pass-through group and pass-through

connections for each subscriber station.

When Mgmt Tag Enable is enabled, this sector controller or subscriber station can be

managed only using VLAN traffic tagged with the value specified in the Mgmt. VID

field. Over-the-air management is possible only after creating a VLAN tagged group and

VLAN tagged connections for each subscriber station.