User Manual
Table Of Contents
- Important Safety & Service Notices
- System Overview
- Web Interface
- CLI Interface
- Diagnostics and Troubleshooting
- Appendices
RedCONNEX
TM
AN-80i PMP
User Manual
70-00072-01-03 Proprietary Redline Communications © 2007 March 19, 2007
Page 19 of 60
RF Channel Frequency: User-assigned RF channel.
Tx Power: The current transmit power level. If ATPC is enabled, this value may be
different than the Tx Power setting in the System Configuration screen.
Link Distance [Miles or Km]: Distance between wireless systems. This may be the
calculated or user-assigned distance (System Configuration screen).
RF Status [Error Code]: A status code indicating the condition of the system RF
components. See 5.5: Status Codes on page 52.
Ethernet MAC Address: System hardware address. This is also printed on a label affixed
to the AN-80i.
IP Address: User-assigned IP address of the AN-80i.
IP Subnet Mask: User-assigned IP subnet mask.
Default Gateway Address: User-assigned IP for the default router or gateway.
3.4.2 Ethernet LAN Statistics
Rx Packets: Total packets received on the Ethernet port.
Rx Packets: Discarded: Total valid Ethernet frames received on the Ethernet port that are
discarded due to lack of buffer space.
Tx Packets: Number of packets transmitted on the Ethernet port (including Ethernet frames
and error correction bytes).
3.4.3 Wireless Statistics
Received Signal Strength: Min: Minimum measured RSSI value.
Received Signal Strength: Mean: Average measured RSSI value.
Received Signal Strength: Max: Maximum measured RSSI value.
SINADR: Average signal to interference, noise, and distortion ratio measured since the last
screen refresh. The measurement includes the effects of AGC.
Rx Packets: Total number of packets received over the wireless interface.
Rx Packets: Retransmitted Number of packets received over the wireless interface that
have been retransmitted by the remote-end system (ARQ mechanism re-transmitting
unacknowledged packets).
Rx Packets - Discarded: Number of received packets discarded due to errors.
Tx Packets: Number of packets transmitted over the wireless interface.
Tx Packets - Retransmitted: Number of packets re-transmitted over the wireless interface
(ARQ mechanism re-transmitting unacknowledged packets).
Tx Packets: Discarded: Total number of packets transmitted over the wireless interface that
were not acknowledged (discarded by remote-end due to errors).
3.4.4 Controls
Reset Statistics: Click this button to zero the counters for the wireless and Ethernet LAN
Statistics displayed on this page.