User Manual

RedCONNEX
TM
AN-80i PMP
User Manual
70-00072-01-03 Proprietary Redline Communications © 2007 March 19, 2007
Page 25 of 60
enabled, you must enter the network address of the SNTP server in the SNTP Server IP
Address field.
SNTP Server IP Address: Enter the network address of the SNTP server. Valid only
when the SNTP Enable field is checked.
Time Zone (GMT): Enter the hours offset from GMT for this time zone. Valid only
when the SNTP Enable field is checked.
Syslog Enable: Check this box to enable the Syslog protocol support. This feature
allows AN-80i log messages to be saved in a central repository. When enabled, you must
enter the network address of the Syslog server in the Syslog Server IP Address field.
Syslog Server IP Address: Enter the network address of the Syslog server. Valid only
when the Syslog Enable field is checked.
Ethernet Mode: Select the operating mode of the Ethernet port.
Auto - Auto-negotiate the speed connection speed.
10 - Operate at 10Base-T only.
100 - Operate at 100Base-T only.
HD - Operate at half-duplex only.
FD - Operate in full duplex only.
Important: The auto-negotiate feature does not detect the speed and duplex of manually
set Ethernet equipment. The auto-negotiate feature works correctly only when both
communicating Ethernet devices are configured for auto-negotiate. Duplex mismatches
may result in an unexpected loss of communications.
HTTP Enable: Check this box to enable the HTTP (Web) interface. If the option is
deselected, only CLI commands will be available.
Telnet Enable: Check this box to enable a Telnet access (CLI) to the AN-80i. Refer to
the CLI commands in section 4: CLI Interface on page 38.
Telnet Port: Enter Telnet port address (default is 23).
SNMP Enable: Check this box
to enable the Simple Network Management Protocol
(SNMP) agent. When this item is checked, clicking on the blue text [Configure SNMP]
adjacent to the check box displays the SNMP Configuration screen. See section 3.10:
SNMP Settings on page 33 for additional information on SNMP settings for the AN-80i.
Wireless Configuration
RF Freq. [MHz]: Enter the center frequency for the RF channel. This setting must be
identical for both AN-80i systems operating as a wireless link. The options key controls
channel availability. Refer to Table 30: Spec - Regional Identification Codes on page 57
for available channels.
Note: To minimize interference, the channel frequencies for AN-80i links operating in
close proximity should be separated by a minimum of the channel size in use (to avoid
overlapping bands).
Auto scan: Check this box
to enable the AN-80i PTP Slave to automatically scan
available channels and locate the current operating frequency of the AN-80i PTP Master.