User Manual

RedCONNEX
TM
AN-80i PMP
User Manual
70-00072-01-03 Proprietary Redline Communications © 2007 March 19, 2007
Page 40 of 60
Table 10: CLI - get
rfstatus: Status RF transmitter.
rssimax: Maximum RSSI.
rssimean: Mean RSSI.
rssimin: Minimum RSSI.
sinadr: Ration of signal to interference + noise.
swver: List the downloaded software versions.
sysuptime: Display the time since the last reboot.
txpower: Current Tx power setting.
ubrate: Current UBR value.
wrxpkt: Number of wireless packets received.
wrxpktd: Number of wireless packets received that were discarded.
wrxpktr: Number of wireless packets that were retransmitted.
wtxpkt: Number of wireless packets transmitted.
wtxpktd: Number of wireless packets transmitted that were discarded.
wtxpktr: Number of wireless packets that were retransmitted.
4.3.3 Reboot
Use the reboot command to remotely reset the AN-80i.
Table 11: CLI - reboot
Command Parameter/Description
reboot
Reboot the AN-80i. There are no parameters associated with this command.
reboot <Enter>
4.3.4 Reset
Use the reset command to set all AN-80i statistics values to zero.
Table 12: CLI - reset
Command Parameter/Description
reset
stats: Reset the AN-80i statistics counters.
reset stats <Enter>
4.3.5 Save
Use the save command to copy edited parameter settings into non-volatile memory. See
section 5.3: Testing and Saving System Parameters on page 50.
save [option] <Enter>
Table 13: CLI - save
Command Parameter/Description
save
config: Save Ethernet, wireless, and user configuration settings.
snmp: Save SNMP settings.
defaultconfig: Overwrite current settings with the factory default Ethernet,
wireless, and SNMP settings.