User Manual

RedCONNEX
TM
AN-80i PMP
User Manual
70-00072-01-03 Proprietary Redline Communications © 2007 March 19, 2007
Page 42 of 60
Table 14: CLI - set
dfsaction: Select the mode of operation for DFS. The system set to master-
mode monitors for interference from radar devices and other equipment using
the same channel frequency. When interference is detected, the system
automatically takes the action selected using the drop-down menu:
<action> - [none=0 | txoff=1 | chgfreq=2]
None: The DFS function is disabled.
Tx Off: Transmission is immediately disabled when radar signals are
detected. This action is recorded in the message log and an SNMP trap
message is sent (if SNMP enabled).
Chg Freq: Relocate transmission to an alternative frequency immediately
when radar signals are detected. This action is recorded in the message log
and a trap message is sent (if SNMP enabled).
dst: Enter the actual length of the path that the wave travels in order to
establish the link. Units are defined by dstmu setting.
This value is used to calculate the transmission-to-response interval and
disregard reflections of the transmitted signal. Used only if dstmod is set to
'manual'.
dstmode: Select the mode for determining the distance of the wireless link.
auto: Distance is calculated automatically by the AN-80i.
manual: Operator enters link distance.
dstmu: Select the measurement unit for the link length (dstmode).
mile - dstmode units are miles
km - dstmode units are kilometers
efw: Enable or disable the Ethernet Follows Wireless function.
off - Disable
on - Enable
When Ethernet Follows Wireless is enabled the Ethernet port status is
controlled to reflect the status of the wireless interface. When the AN-80i
detects that the wireless interface has failed (or is manually disabled), the local
Ethernet port is immediately disabled When the AN-80i re-establishes the
wireless link, the Ethernet port is re-enabled..
encen: Enable or disable the encryption function.
off - Disable
on - Enable
If encryption is enabled, the correct encryption keys must be entered on both
communicating systems.
enckey: Enter the encryption key. If encryption is enabled, the correct
encryption keys must be entered on both communicating systems. Used only if
encen is set to 'on'.
ethmode: Enter the Ethernet speed and duplex setting.
auto - Auto-negotiate
10hd - 10Base-T Half Duplex
10fd - 10Base-T Full Duplex
10hd - 100Base-T Half Duplex
100fd - 100Base-T Full Duplex