User Manual

RedCONNEX
TM
AN-80i PMP
User Manual
70-00072-01-03 Proprietary Redline Communications © 2007 March 19, 2007
Page 43 of 60
Table 14: CLI - set
flowctrl: Enable or disable the flow control function. The Flow control feature
enables the AN-80i to request other Ethernet devices to pause transmission
during busy periods.
off - Disable
on - Enable
gateway: Enter the IP address of the default gateway on this segment.
gmt: Enter the time offset from GMT (i.e., -5 for EST).
http: Enable or disable the HTTP function. When disabled, the Web interface
will not be available.
off - Disable
on - Enable
ipaddr: Enter the IP address of the AN-80i.
maxtxpower: Enter the Tx power level (dBm).
This setting is for the transceiver output only. The actual EIRP depends on the
gain of the connected antenna. See section 0:
Certified Antennas on page 55 for a list the maximum transmit power setting
based on the antenna gain for a series of frequency settings. The maximum
value for this field is determined by the options key.
mrate: Enter the maximum uncoded burst rate (Mbps). Entry values are
dependant on the channel bandwidth (chwidth).
10 MHz: 3, 4.5, 6, 9, 12, 18, 24 or 27
20 MHz: 6, 12, 18, 24, 30, 36, 48, or 54
40 MHz: 12, 24, 36, 48, 60, 72, 96, or 108
The maximum value for this field is determined by the options key.
netmask: Enter the IP netmask.
optionskey: Enter the options key string. A permanent Options Key must be
entered for in-service operation: the temporary options key shipped with the
system will expire and service will be interrupted.
radio: Enable or disable the radio transmitter.
off - Disable
on - Enable
ratedif: Enter the number of modulation levels to step down during re-
transmission of errored wireless packets. The level can be set from 0 to 7
(recommended value = 2).
rffreq: Enter the center frequency for the RF channel. When operating multiple
links in close proximity, channel frequencies should be separated by a minimum
of the channel size to minimize interference. For example, when operating in
with 20 MHz channels, the separation must be greater than 20 MHz.
snmp: SNMP enable setting.
off - Disable the SNMP agent.
on - Enable the SNMP agent.
snmptraplink: Enable or disable sending an SNMP trap message for each link-
up and link-down event.
<setting> - [on | off]
snmptraps: Enable or disable sending all SNMP traps.
<setting> - [on | off]