User's Manual
Table Of Contents
- Important Safety & Service Notices
- System Overview
- Web Interface - PTP
- PMP Operation
- CLI Interface
- Diagnostics and Troubleshooting
- Appendices
User
AN-80i
Manual
70-00072-01-06a Proprietary Redline Communications © 2008 Page 39 of 96 June 1, 2008
SNMP Traps Enabled: Check this box to enable SNMP traps to be sent. If the box is
not checked, all SNMP traps are disabled.
Link Up/Down Trap Enabled: Check this box to enable an SNMP trap to be
generated for each link up and link down event.
Save Traps: Click the Save Traps button to save changes to the SNMP trap settings.
3.10.1 Change SNMP Community
Each entry in the SNMP Community Management table may be changed individually.
Click the Chg button adjacent to any entry to modify the settings.
Figure 16: Web - SNMP Community Configuration Screen
Index: Display the unique reference number for this entry.
Community Name: Enter or modify the SNMP community name for this entry.
Access Rights: Select the access permissions for this entry.
None: Deny read and write permission for this entry.
Read: Grant read access permission only for this entry. Deny write permission.
Write: Grant write access permission only for this entry. Deny read permission.
Read&Write: Grant read and write access permission for this entry.
Change Community: Click the Change Community button to copy these settings to the
community settings table. This action does not permanently save changes. To save
changes to the community settings you must also click the Save Comm button in the
SNMP Configuration screen.