User's Manual
Table Of Contents
- Important Safety & Service Notices
- System Overview
- Web Interface - PTP
- PMP Operation
- CLI Interface
- Diagnostics and Troubleshooting
- Appendices
User
AN-80i
Manual
70-00072-01-06a Proprietary Redline Communications © 2008 Page 40 of 96 June 1, 2008
3.10.2 Change SNMP Trap Configuration
Each of the eight entries in the SNMP Traps Management table may be changed
individually. Click the Chg button to modify the settings for the adjacent entry.
Figure 17: Web - SNMP Trap Configuration Screen
Index: Display the table position number for this entry. Position 0 is the first entry.
IP Address: Enter the IP address (IPv4) associated with this SNMP alarm.
Port: Enter the destination port address associated with this SNMP alarm.
Community Name: Enter the SNMP community name for this entry.
Change Trap: Click the Change Trap button to copy these settings to the community
settings table. This action does not permanently save changes. To save changes to the
SNMP trap settings you must click the Save Traps button in the SNMP Configuration
screen.