User's Manual
Table Of Contents
- Important Safety & Service Notices
- System Overview
- Web Interface - PTP
- PMP Operation
- CLI Interface
- Diagnostics and Troubleshooting
- Appendices
User
AN-80i
Manual
70-00072-01-06a Proprietary Redline Communications © 2008 Page 59 of 96 June 1, 2008
Figure 34: PMP - Pass-through Only Deployment
The procedures provided below include steps to setup a basic working configuration for
initial testing, and then to introduce VLAN traffic controls.
4.7.1 Configure Pass-Through Operation
For initial installation and testing, it is recommended to setup a PMP configuration
without
VLAN support. Use the following steps to configure a PMP pass-through link.
Step 1: Create New Link for Each Subscriber
1. Click New Link to display the Link Configuration screen.
2. Enter a unique name for this link in the Link Name field.
3. Enter the MAC address of the subscriber station in the Peer MAC field.
4. Enter the UBR for this link (based on link budget calculations).
5. Use the default values for all other fields.
6. Click the Apply button to save and activate these settings.
7. Repeat steps 1 - 6 for each subscriber station.