User's Manual
Table Of Contents
- Important Safety & Service Notices
- System Overview
- Web Interface - PTP
- PMP Operation
- CLI Interface
- Diagnostics and Troubleshooting
- Appendices
User
AN-80i
Manual
70-00072-01-06a Proprietary Redline Communications © 2008 Page 64 of 96 June 1, 2008
5.3.2 Clear
Use the clear command to delete all IDs from an ID table.
Table 16: CLI - clear
PTP PMP Parameter/Description
√
clear
idtable - Clear all the IDs
5.3.3 Del
Use the del command to delete a specific ID.
Table 17: CLI - del
PTP PMP Parameter/Description
√
del
<id> - [id number]
5.3.4 Enable
Use the enable command to re-enable a specific ID (that was disabled).
Table 18: CLI - enable
PTP PMP Parameter/Description
√
enable
<id> - [id number]
5.3.5 Freq
Use the freq command to configure frequency ranges when using autoscan or DFS.
Table 19: CLI - enable
PTP PMP Parameter/Description
√
freq
add Add a frequency range (up to 32 ranges).
<begin> - start frequency (MHz)
<end> - end frequency (MHz)
del Delete a frequency validation range
<index> - Frequency validation range index
print Print the list of frequency validation ranges.
Local frequency ranges:
<index> <begin> <end>
reload Reload the active list of frequency validation ranges.