User's Manual

User
AN-80i
Manual
70-00072-01-06a Proprietary Redline Communications © 2008 Page 65 of 96 June 1, 2008
5.3.6 Get
Use the get command to view system parameters. Use the following general format to
view a parameter:
get [field] <Enter>
Table 20: CLI - get
PTP PMP Parameter/Description
√ calcdst: Calculated link distance between units.
√ √ erxpkt: Number of Ethernet packets received.
√ √ erxpktd: Number of Ethernet packets received that were discarded.
√ √ etxpkt: Number of Ethernet packets transmitted.
√ √ mac: AN-80i MAC address.
√ √ radiotype: Radio type.
√ √ rffreq: Current RF frequency setting.
√ rflink: Status of the RF link.
√ √ rfstatus: Status RF transmitter.
√ rssimax: Maximum RSSI.
√ rssimean: Mean RSSI.
√ rssimin: Minimum RSSI.
√ sinadr: Ration of signal to interference + noise.
√ √ swver: List the downloaded software versions.
√ √ sysuptime: Display the time since the last reboot.
√ √ txpower: Current Tx power setting.
√ ubrate: Current UBR value.
√ wrxpkt: Number of wireless packets received.
√ wrxpktd: Number of wireless packets received that were discarded.
√ wrxpktr: Number of wireless packets that were retransmitted.
√ wtxpkt: Number of wireless packets transmitted.
√ wtxpktd: Number of wireless packets transmitted that were discarded.
√ wtxpktr: Number of wireless packets that were retransmitted.
√ activeids: Number of active IDs.
√ activelinks: Number of the active links.
√ boardtype: Board type.
√ dldpkt: Downlink discarded packets counter.
√ dlrpkt: Downlink Rx packets counter.
√ dltpkt: downlink Tx packets counter.
√ idenable: ID status.
√ lactive: Link active status.
√ ldlblk: Downlink total blocks counter.
√ ldlbr: Downlink burst rate.
√ ldldblk: Downlink discarded blocks counter.