User's Manual

& User

AN-80i

Manual

HTTP Enable: Check this box to enable the HTTP (Web) interface. If the option is

deselected, only CLI commands will be available.

Telnet Enable: Check this box

to enable a Telnet access (CLI) to the AN-80i. Refer

to the CLI commands in CLI Interface on page 66.

Telnet Port: Enter Telnet port address (default is 23).

SNMP Enable: Check this box

to enable the Simple Network Management Protocol

(SNMP) agent. When this item is checked, click on the blue text

[Configure SNMP]

adjacent to the check box to display the SNMP Configuration screen.

Mgmt. Tag Enable: Check

this box to enable VLAN tagged traffic.

The Mgmt Tag Enable setting is disabled (factory default) when shipped from the factory

or following a long-reset operation. In this mode the PTP Master and PTP Slave can be

managed through the local Ethernet port using untagged traffic. Over-the-air

management is possible only after creating a pass-through group and pass-through

connections for each PTP Slave.

When Mgmt Tag Enable is enabled, this PTP Master or PTP Slave can be managed

only using VLAN traffic tagged with the value specified in the Mgmt. VID field. Over-the-

air management is possible only after creating a VLAN tagged group and VLAN tagged

connections for each PTP Slave.

It is recommended to create and test a VLAN group for tagged management traffic

before activating the Mgmt Tag Enable function. Set the associated QoS and priority

values to ensure management traffic has adequate priority and bandwidth during system

operation.

Mgmt. VID: Enter the VLAN ID. When Mgmt. Tag Enable is selected, the system

recognizes only management commands with this VLAN ID.

Important: The VLAN network support should be verified before enabling this feature

to ensure the AN-80i system will be reachable using the VLAN tagged traffic.